Specifications

1260-14 User Manual
Module Specific Syntax 3-12 EADS North America Defense
Test and Services, Inc. © 1992
transfer the read data. It is identical to the standard byte width
read with the exception that binary formatting is not available, and
the output contains no header line, END line, module address or
port numbers. All the output line contains is the port data
separated by commas. Data is returned in least significant port to
most significant port order. This type of read is only available on
firmware revisions 18.1 or later.
Example 4:
Assume that ports 5-11 are defined as asynchronous and are tri-
stated, port 5 is sensing a hex 7f, port 6 is sensing a hex 01, port 7
is sensing a hex c3 and the user sends the following command:
READ 1.5-7,Z,H
The user would read back:
7F,01,C3<CR><LF>
RESET command
Syntax: RES[ET]
Description: The RESET command resets the 1260-14 card to
the power-up state. Specifically, the following attributes are
programmed after the RESET command is executed:
BUSY Polarity Positive
CLKIN Polarity Positive
Synchronous Ports None (SYNC 0)
Arm Off
All Ports Tri-stated
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com