Specifications

1260-14 User Manual
Module Specific Syntax 3-6 EADS North America Defense
Test and Services, Inc. © 1992
Module Specific
Syntax
The 1260-14 Digital I/O module supports the PDATAOUT,
PSETUP, READ, RESET, SETUP, and WRITE commands. The
general form of the module specific syntax for the 1260-14 Digital
I/O module is:
command address.parameters
where:
command is one of the 1260-14 module specific
commands.
address is the module address set by SW1 on the 1260-14
(1-12).
parameters are the command specific parameters and data.
NOTE:
The address used here is not the VXIbus defined logical
address of the Master. It is a designation unique to the 1260
Series and is used by the 1260 Option 01 to identify
individual 1260 modules. This switch setting is a
requirement since a single Option 01 can control multiple
1260 Series modules. This address corresponds to the
binary value of the switch setting of SW1 on the switching
module PCB, and can take on the values from 1 to 12.
Syntax Notations
and Conventions
The following syntax notations and conventions are used
throughout the manual:
All terms in upper case letters are used directly in the command
syntax, although case is not important in the actual command
string sent to the Option 01.
All items in brackets ( [ ] ) are optional.
All lower case letters within greater/less than pairs ( < > ) are to be
replaced by a numeric value, as specified in the syntax description.
A vertical bar ( | ) represents the "or" function, and specifies that
the user must select one and only one of the items separated by
bars.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com