Technical data

Publication No. 980824-118 Rev. A 1260-118/-118A User Manual
Astronics Test Systems Installation Instructions 2-7
Mating
Connectors
The following 1260-118
mating connector accessories are
available:
160 Pin Connector Kit with backshell and pins, P/N
407664
The 160 Pin Connector Kit consists of a connector housing,
aluminum backshell, and 160 crimp pins. After wire attachment,
the pin is inserted into the housing and will snap into place,
providing positive retention.
160 Pin Cable Assembly, 6 Ft., 24 AWG, P/N
407408-001
The 160 Pin Cable Assembly uses 24 AWG cable with crimp pins
to mate with the 1260-118. The other cable end is unterminated.
Refer to Table 2-1 for channel-to-pin mapping information.
The suggested crimp hand tool is PN991020. The crimp pin
insertion tool is P/N 990898. The corresponding pin removal tool
is P/N 990899.
The following 1260-118A
mating connector accessories are
available:
64 Pin DIN, IDC Connector P/N 602004
This connector is for use with flat ribbon cable. This allows an
economical means of cable assembly. Not recommended for
currents greater than 1 A AC/DC per pin.
64 Pin DIN Crimp Connector Body P/N 602159-064
64 Pin DIN Crimp Pin P/N 602159-900
The crimp connector and pins allow more flexibility and better
performance, 2 Amps, rather than the 1 Amp for the IDC
connector. The crimp hand tool is P/N 990897. The insertion tool
is P/N 990898. The extraction tool is P/N 990899.