User manual

Publication No. 980935 Rev. M 3152B User Manual
Astronics Test Systems ArbConnection 4-19
Half Cycle
The Half Cycle panel contains controls that select the half cycle
functions and adjust the half cycle parameters. To access the
Arbitrary/Sequence panel, click the Operation button on the Panels
bar (Figure 4-12). Then click the Half Cycle button that drops down
below the Operation button. The half cycle panel will then open.
The half cycle functions are generated with variable and
controllable delay between the halves. If triggered mode, one half
at a time is generated as a result of a trigger signal regardless of
the programmed delay value. The half cycle functions have
different limitations compared to the standard functions; these are
listed in Appendix A. The half cycle panel and the various
parameters that control these functions are described below.
Figure 4-12, Half Cycle Panel
1. Click Operation button
2. Additional buttons
will drop down
3. Click Half Cycle button
4. The Half Cycle panel will
then open