Specifications

SCPI Command Reference 4-11
Arbitrary Waveform,
Sequence, and
Shared Memory
Command Summary
Arbitrary Waveform commands allow the definition of segments and
their corresponding lengths, addition and deletion of segments, and
the loading waveform data. Sequence commands control which
segments are linked and the number of times each segment is
repeated. The shared memory commands place the Model 3152 in
a special data transfer mode where the Model 3152's message-
based interface is bypassed and data is loaded directly from the
VXIbus. Optional modes are omitted from these commands.
Defaults are shown in bold.
Command and Parameters
TRACe #<binary_block>
TRACe:DEFine {<segment_number>, <length>}
TRACe:DELete <segment_number>
TRACe:DELete:ALL
TRACe:SELect <segment_number>
FORMat:BORDer {NORMal | SWAPped}
FORMat:BORDer?
SEQuence:DEFine <step_number>, <segment_number>, <#_repeat>
SEQuence:DELete <sequence_number>
SEQuence:DELete:ALL
SEQuence:SELect <sequence_number>
SMEMory:MODE {READ | WRITe}
SMEMory {OFF | ON}
Modulation Command
Summary
The Modulation Commands controls amplitude modulation
parameters. Optional modes are omitted from these commands.
Factory defaults after *RST are shown in bold typeface. Parameter
low and high limits are given where applicable.
Command and Parameters Low Limit High Limit Default
[SOURce:]
AM <value> 0 200 50
AM?
AM:INTernal:FREQuency <value> 10 500 100
AM:INTernal:FREQuency?
AM:EXECute
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com