Specifications

SCPI Command Reference 4-10
Standard Waveform
Command Summary
The Standard Waveform Commands control the various parameters
of the standard output functions. Optional modes are omitted from
these commands. Factory defaults after *RST are shown in bold
typeface. Parameter low and high limits are given where applicable.
The Standard Waveforms parameters could be used for the APPLy
command.
Command and Parameters Low Limit High Limit Default
[SOURce:]
SINusoid:PHASe <value> 0 360 0
SINusoid:PHASe?
SINusoid:POWer <value> 1 9 1
SINusoid:POWer?
TRIangle:PHASe <value> 0 360 0
TRIangle:PHASe?
TRIangle:POWer <value> 1 9 1
TRIangle:POWer?
SQUare:DCYCle <value> 1 99 50
SQUare:DCYCle?
PULSe:DELay <value> 0 99.9 10.0
PULSe:DELay?
PULSe:WIDTh <value> 0 99.9 10.0
PULSe:WIDTh?
PULSe:TRANsition <value> 0 99.9 10.0
PULSe:TRANsition?
PULSe:TRANsition:TRAiling <value> 0 99.9 10.0
PULSe:TRANsition:TRAiling?
RAMP:DELay <value> 0 99.9 10.0
RAMP:DELay?
RAMP:TRANsition <value> 0 99.9 10.0
RAMP:TRANsition?
RAMP:TRANsition:TRAiling <value> 0 99.9 10.0
RAMP:TRANsition:TRAiling?
SINC:NCYCle <value> 4 100 10
SINC:NCYCle?
GAUSsian:EXPonent <value> 1 200 10
GAUSsian:EXPonent?
EXPonential:EXPonent <value> -200 200 -10
EXPonential:EXPonent?
DC <%_amplitude> -100 100 100
DC?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com