User`s manual

32 RabbitLink (EG2100)
E.1 Configuration Commands
These commands are used to set network parameters and to password protect the RabbitLink.
set gateway <IP address>
This command sets the IP address for the gateway.
IP address The IP address for the gateway in dotted decimal format. The factory
default is 10.10.6.1.
set hostname <name>
This command allows the RabbitLink to be identified with a unique name, that may be up
to 40 characters long.
name User-chosen string. The factory default is RabbitLink.
set ip <IP address>
This command sets the IP address for the RabbitLink.
IP address The IP address for the RabbitLink in dotted decimal format. The factory
default is 10.10.1.100.
set netmask x.x.x.x
This command sets the netmask.
x.x.x.x This is the dotted decimal format of the netmask. The factory default is
255.255.255.0.
set passphrase
This command will prompt for a passphrase twice to confirm that the passphrase was cor-
rectly entered.The charactersare not echoed back as a security measure. As anothersecurity
measure, the passphrase is hashed before it is stored on the RabbitLink. Whenever a new
session starts with Dynamic C or the RFU, the user will be asked for the passphrase. It
should be as long as possible to increase security, up to the maximum length of 255 charac-
ters.