User`s manual

User’s Manual 41
set passphrase
This command will prompt for a passphrase twice to confirm that the passphrase was en-
tered correctly. The characters are not echoed back as a security measure. As another se-
curity measure, the passphrase is hashed before it is stored on the RabbitLink. Whenever
a new session starts with Dynamic C or the RFU, the user will be asked for the passphrase.
It should be as long as possible to increase security, up to the maximum length of 255
characters.
set port x
This command sets the TCP port number. If the RabbitLink is being used behind a firewall,
it may be necessary to punch a hole in the firewall to allow remote access.
x The port number. The factory default is 4244.
set dhcp <on | off>
This command enables and disables the use of any DHCP server that is available on the net-
work. The default condition is on. This command is only available with RabbitLink serial
console version 2.00 and later.