User`s manual

40 RabbitLink (EG2110)
E.1 Configuration Commands
These commands are used to set network parameters and to password-protect the
RabbitLink.
set consbaud
This command sets the baud rate of the console communications.
57600 57,600 is the default console baud rate.
set gateway <IP address>
This command sets the IP address for the gateway.
IP address The IP address for the gateway in dotted decimal format. The factory
default is 10.10.1.1.
set hostname <name>
This command allows the RabbitLink to be identified with a unique name, that may be up
to 40 characters long.
name User-chosen string. The factory default is RabbitLink.
set ip <IP address>
This command sets the IP address for the RabbitLink.
IP address The IP address for the RabbitLink in dotted decimal format. The factory
default is 10.10.1.100.
set netmask x.x.x.x
This command sets the netmask.
x.x.x.x This is the dotted decimal format of the netmask. The factory default is
255.255.255.0.