Manualshelf

User`s manual

ManualsBrandsRabbitLink ManualsComputer equipmentEG2110
41424344454647484950
38 RabbitLink (EG2110)
The DIAG Connector
The
DIAG
connector is used to configure network parameters for the RabbitLink. It is also
used to treat the programming port as a regular serial port; because the programming cable
contains an active circuit board that converts RS-232 voltage levels used by the PC serial
port to CMOS voltage levels used by the Rabbit, the
DIAG
connector allows the program-
ming cable to be used as an RS-232 to CMOS level converter for serial communication.
The /RESET line and the SMODE1 and SMODE0 pins are not present in the
DIAG
con-
nector.