User`s manual

28 RabbitLink (EG2110)
2. Install light pipes (optional).
Light pipes are included in the tool kit so you can see the LEDs on the RabbitLink
board once the enclosure is assembled.
Figure B-2. Install Light Pipes in Enclosure Top
With the enclosure top positioned as shown in Figure B-2, insert three light pipes into
the slots identified in Figure B-2. Position the light pipes snugly against the enclosure
top since there is little clearance between the light pipes and the LEDs on the Rab-
bitLink board. The light pipes snap in place. Verify that the light pipes are aligned over
the LEDs, then apply a drop of cyanoacrylate or contact cement to the inside of the
enclosure around each light pipe to hold it in place.
NOTE: Once the glue is applied, it will not be possible to change the alignment of the
light pipes without damaging the plastic enclosure.
3. Attach the enclosure top to the base.
Position the enclosure top over the plastic enclosure base as shown below in Figure B-3.
Attach the enclosure top to the base using the two 4-40 × ½ screws supplied. If you
installed the light pipes, be sure they are aligned over the LEDs as shown.
Notched
side
Light pipe
flange is firmly
against
enclosure