User`s manual

User’s Manual 21
2. Use the RFU version 2.0 or later to load the DOWNLOAD.BIN firmware or the
CLEAR_PARAM.BIN binary image onto the RabbitLink board.
3. Disconnect the programming cable.
4. Unplug the power supply, then plug the power supply back in. This resets the Rabbit-
Link from Program Mode to Run Mode.
3.2.2 Firmware Upgrades
Follow the above steps to install a firmware upgrade. Just substitute the name of the firm-
ware upgrade for the firmware binary image file (DOWNLOAD.BIN). Firmware upgrades
will be available at www.rabbit.com.
3.3 Serving Web Pages and Sending E-Mail
The RabbitLink is intended for downloading and debugging across an Ethernet-based
network with a Rabbit-based target. However, it is possible to use the RabbitLink to send
e-mail and serve Web pages from the Rabbit-based target, though this is not recommended.
3.3.1 Using RabbitLink Features
RabbitLink console commands may be used to send e-mail and serve web pages. A com-
plete list of the available commands are in Appendix E, “Serial Console Commands.”
Prior to Dynamic C 7.20, a console function call existed for target applications to send
console commands to the RabbitLink. Please see Appendix E.6 for the function
descriptions.
Starting with Dynamic C 7.20, the console commands are sent to the RabbitLink through
the serial port interface.