User`s manual

User’s Manual 15
2.3 Target System Connections to the RabbitLink
After the network addresses have been set, put aside the programming cable and connect
the program download cable as shown in Figure 6. Two program download cables are
included with the RabbitLink — one is used with 2 mm programming headers, and the other
is used with 1.27 mm programming headers. One end of the program download cable
connects to the programming header of the Rabbit-based target system. The other end
connects to the PROG OUT header (J1 for 1.27 mm programming headers on the target
system and J9 for 2 mm programming headers) of the RabbitLink board.
Figure 6. Connect Rabbit-Based Target System to RabbitLink
Programming Port
Flash
EPROM
Flash
EPROM
J1
J9
1.27 mm
2 mm
SRAM
Colored edge
lines up with
pin 1
Colored edge
Rabbit-Based
Embedded System
Program
Download
Cable
90
15
65
J3
J1/J9
PROG OUT