User`s manual

User’s Manual 11
2. Connect the programming cable
You must connect the programming cable to configure network parameters from your
PC. Connect the 10-pin
DIAG connector of the programming cable to header J8, which
is labeled PROG IN, on the RabbitLink. Ensure that the colored edge lines up with pin 1
as shown. Connect the other end of the programming cable to a COM port on your PC.
Figure 4. Programming Cable Connections
NOTE: Some PCs now come equipped only with a USB port. It may be possible to use
an RS-232/USB converter (Part No. 540-0070) with the programming cable supplied
with the Tool Kit. Note that not all RS-232/USB converters work with Dynamic C.
NOTE: Be sure to use the programming cable (Part No. 101-0513) supplied with the
RabbitLink Tool Kit—the programming cable has red shrink wrap around the RS-232
converter section located in the middle of the cable. Programming cables from other
Rabbit Semiconductor kits are not designed to work with the RabbitLink.
Flash
EPROM
Flash
EPROM
90
15
65
SRAM
Colored edge
down
DIAG
PROG
Programming Cable
J9
PROG OUT IN PROG
J8
To
PC COM port
DIAG