User`s manual

10 RabbitLink (EG2110)
2.1 RabbitLink Physical Connections
1. Attach the RabbitLink board to the plastic enclosure base.
Position the RabbitLink board over the plastic enclosure base as shown below in
Figure 3. Attach the RabbitLink board to the base at the top left and bottom right posi-
tions using the two 4-40 × ¼ screws supplied.
Figure 3. Attach RabbitLink Board to Plastic Enclosure Base
The plastic enclosure base facilitates handling the RabbitLink during development. It
is available in the RabbitLink Tool Kit.
NOTE: Appendix B, “Plastic Enclosure,” provides additional information and specifica-
tions for the plastic enclosure.
Flash
EPROM
Flash
EPROM
90
15
65
SRAM