User`s manual

90 RabbitCore RCM3400
B.5 RCM3400 Prototyping Board Jumper Configurations
Figure B-12 shows the header locations used to configure the various RCM3400 Prototyp-
ing Board options via jumpers.
Figure B-12. Location of Configurable Jumpers on RCM3400 Prototyping Board
Table B-6 lists the configuration options using either jumpers or 0  surface-mount resistors.
Table B-6. RCM3400 Prototyping Board Jumper Configurations
Header Description Pins Connected
Factory
Default
JP1 ADC_IN0–ADC_IN1
1–2 Tied to VREF
2–3 Tied to analog ground
×
JP2 ADC_IN2–ADC_IN3
1–2 Tied to VREF
2–3 Tied to analog ground
×
Battery
JP1
JP2
JP9
JP5
JP3
JP10
JP8
JP4
JP6
JP7
Note
JP6 and JP7 are located
under the RCM3400
(if the RCM3400 module
is plugged in)