User`s manual
Table Of Contents
- RabbitCore RCM3200 User's Manual
- Table of Contents
- 1. Introduction
- 2. Hardware Setup
- 3. Running Sample Programs
- 4. Hardware Reference
- 5. Software Reference
- 6. Using the TCP/IP Features
- Appendix A. RCM3200 Specifications
- Appendix B. Prototyping Board
- Appendix C. LCD/Keypad Module
- Appendix D. Power Supply
- Appendix E. Motor Control Option
- Notice to Users
- Index
- Schematics
User’s Manual 79
C.6 Bezel-Mount Installation
This section describes and illustrates how to bezel-mount the LCD/keypad module. Fol-
low these steps for bezel-mount installation.
1. Cut mounting holes in the mounting panel in accordance with the recommended dimen-
sions in Figure C-8, then use the bezel faceplate to mount the LCD/keypad module onto
the panel.
Figure C-8. Recommended Cutout Dimensions
2. Carefully “drop in” the LCD/keypad module with the bezel and gasket attached.
3.400
(86.4)
3.100
(78.8)
2.870
(72.9)
0.230
(5.8)
0.125 D, 4x
(3)
CUTOUT
0.130
(3.3)