User`s manual
Table Of Contents
- RabbitCore RCM3200 User's Manual
- Table of Contents
- 1. Introduction
- 2. Hardware Setup
- 3. Running Sample Programs
- 4. Hardware Reference
- 5. Software Reference
- 6. Using the TCP/IP Features
- Appendix A. RCM3200 Specifications
- Appendix B. Prototyping Board
- Appendix C. LCD/Keypad Module
- Appendix D. Power Supply
- Appendix E. Motor Control Option
- Notice to Users
- Index
- Schematics
26 RabbitCore RCM3200
4.3.2 Standalone Operation of the RCM3200
The RCM3200 must be programmed via the Prototyping Board or via a similar arrange-
ment on a customer-supplied board. Once the RCM3200 has been programmed success-
fully, remove the serial programming cable from the programming connector and reset the
RCM3200. The RCM3200 may be reset by cycling the power off/on or by pressing the
RESET button on the Prototyping Board. The RCM3200 module may now be removed
from the Prototyping Board for end-use installation.
CAUTION: Disconnect power to the Prototyping Board or other boards when removing
or installing your RCM3200 module to protect against inadvertent shorts across the
pins or damage to the RCM3200 if the pins are not plugged in correctly. Do not reapply
power until you have verified that the RCM3200 module is plugged in correctly.