User`s manual
Table Of Contents
- RabbitCore RCM3200 User's Manual
- Table of Contents
- 1. Introduction
- 2. Hardware Setup
- 3. Running Sample Programs
- 4. Hardware Reference
- 5. Software Reference
- 6. Using the TCP/IP Features
- Appendix A. RCM3200 Specifications
- Appendix B. Prototyping Board
- Appendix C. LCD/Keypad Module
- Appendix D. Power Supply
- Appendix E. Motor Control Option
- Notice to Users
- Index
- Schematics
User’s Manual 5
2. HARDWARE SETUP
This chapter describes how to set up and connect the RCM3200 and
the Prototyping Board included in the Development Kit.
NOTE: This chapter (and this manual) assume that you have the RCM3200 Development
Kit. If you purchased an RCM3200 module by itself, you will have to adapt the infor-
mation in this chapter and elsewhere to your test and development setup.
2.1 Development Kit Contents
The RCM3200 Development Kit contains the following items:
• RCM3200 module.
• Prototyping Board.
• AC adapter, 12 V DC, 1 A. (Included only with Development Kits sold for the North
American market. A header plug leading to bare leads is provided to allow overseas
users to connect their own power supply with a DC output of 8–24 V at 8 W.)
• 10-pin header to DB9 programming cable with integrated level-matching circuitry.
• Dynamic C
®
CD-ROM, with complete product documentation on disk.
• Getting Started instructions.
• A bag of accessory parts for use on the Prototyping Board.
• Registration card.