User`s manual

User’s Manual 25
It is recommended that you allow for an “exclusion zone” of 0.04" (1 mm) around the
RCM3000 in all directions when the RCM3000 is incorporated into an assembly that
includes other printed circuit boards. This “exclusion zone” that you keep free of other
components and boards will allow for sufficient air flow, and will help to minimize any
electrical or electromagnetic interference between adjacent boards. An “exclusion zone”
of 0.08" (2 mm) is recommended below the RCM3000 when the RCM3000 is plugged
into another assembly using the shortest connectors for headers J1 and J2. Figure A-2
shows this “exclusion zone.”
Figure A-2. RCM3000 “Exclusion Zone”
0.08
(2)
0.08
(2)
0.6
(16)
1.93
(49.0)
0.6
(16)
J1J2
Exclusion
Zone
2.725
(69.2)
1.850
(47.0)
2.805
(71.2)