User`s manual

User’s Manual 29
4.3.2 Standalone Operation of the RCM2300
The RCM2300 must be programmed via the RCM2200/RCM2300 Prototyping Board or
via a similar arrangement on a customer-supplied board. Once the RCM2300 has been
programmed successfully, remove the programming cable from the programming connec-
tor and reset the RCM2300. The RCM2300 may be reset by cycling the power off/on or by
pressing the
RESET button on the Prototyping Board. The RCM2300 module may now be
removed from the Prototyping Board for end-use installation.
CAUTION: Power to the Prototyping Board or other boards should be disconnected
when removing or installing your RCM2300 module to protect against inadvertent
shorts across the pins or damage to the RCM2300 if the pins are not plugged in
correctly. Do not reapply power until you have verified that the RCM2300 module is
plugged in correctly.