User`s manual

8 RabbitCore RCM2300
2.1 Connections
There are three steps to connecting the Prototyping Board for use with Dynamic C and the
sample programs:
1. Attach the RCM2300 to the Prototyping Board.
2. Connect the programming cable between the RCM2300 and the PC.
3. Connect the power supply to the Prototyping Board.
2.1.1 Attach RCM2300 to Prototyping Board
Turn the RCM2300 module so that the header pins and the mounting hole of the RCM2300
line up with the sockets and mounting hole on the Prototyping Board as shown in Figure 1.
Align the module header pins from headers J4 and J5 on the bottom side of the RCM2300
into header sockets J1 and J2 on the Prototyping Board.
Figure 1. Install the RCM2300 on the Prototyping Board
J2
PE3
GND
PD6
PD2
PD1
PD0
PD7
J1
Y1
VCC
VBAT
+
GND
R22
R21
C14
C13
D2
D3
C3
R38
R41
R39
RT1
D1
R7
R8
U6
R37
Y3
R18 C24
U2
R29
C23
C9
R17
R19
G
R34
WD
J3
VCC
VCC
PE6
BEN
C4
R36
C27
R1
C8
R2
C10
JP2
JP1
R23
R13
C11
U1
R15
C12
C15
R26
Q2 Q3
Q4
Q5
R20
J2
CAUTION
Battery
J1
Line up the
mounting holes
RCM2300
Prototyping
Board