User`s manual

6 RabbitCore RCM2200
2.1 Connections
There are four steps to connecting the Prototyping Board for use with Dynamic C and the
sample programs:
1. Attach the RCM2200 module to the Prototyping Board.
2. Connect the programming cable between the RCM2200 module and the workstation PC.
3. Connect the power supply to the Prototyping Board.
2.1.1 Attach Module to Prototyping Board
Turn the RCM2200 module so that the Ethernet connector end of the module extends off
the Prototyping Board, as shown in Figure 1 below. Align the pins from headers J4 and J5
on the bottom side of the RCM2200 with header sockets J1 and J2 on the Prototyping
Board.
Figure 1. Installing the RCM2200 on the Prototyping Board
J2
J1
R2
C3
D2
R7
C27
R8
R36
RT1
R41
R37
R38
D1
R39
Y2
C2
C1
U8
U7
U3
U6
C7
GND
GND
EGND
DS2
LNK
ACT
DS1
R19
Q3
Q4
Q5
Q2
R1
Y1
C4
C17
C8
R9
R13
R11
U1
BT1
R15
C12
R17
R20
C13
Y3
R16
R22
R21
C14
R18
C25
C28
D3
J2
JP4
JP3
JP1
JP6
C30
JP2
JP5
C29
U2
CAUTION
Battery
J1
Line up the
mounting holes
RCM2200
Prototyping
Board