User`s manual

Getting Started Manual Hardware Setup 2–3
and bottom of the Prototyping Board.)
Each SMT pad is connected to a hole
designed to accept a 30 AWG solid wire.
Slave Module Connectors A second
set of connectors is pre-wired to permit
installation of a second, slave RCM2200
or RCM2300 module. This capability is
reserved for future use, although the sche-
matics in this manual contain all of the
details an experienced developer will need
to implement a master-slave system.
Figure 2–1: The RCM2200 Prototyping Board.
RCM2200/2300
Master Module
Connectors
Power
LED
Power
Connector
Voltage
Regulator
Master Module
Extension Headers
Backup
Battery
User Switches
& LEDs (2 each)
Through-Hole
Prototyping Area
SMT Device
Prototyping Area
Vcc & Ground
Busses
RCM2200/2300
Slave Module
Connectors
Slave Module
Extension Headers
Reset
Switch