User`s manual

User’s Manual 33
4.3.2 Standalone Operation of the RCM2100
The RCM2100 must be programmed via the RCM2100 Prototyping Board or via a similar
arrangement on a customer-supplied board. Once the RCM2100 has been programmed
successfully, remove the programming cable from the programming connector and reset
the RCM2100. The RCM2100 may be reset by cycling the power off/on or by pressing the
RESET button on the Prototyping Board. The RCM2100 module may now be removed
from the Prototyping Board for end-use installation.
CAUTION: Power to the Prototyping Board or other boards should be disconnected
when removing or installing your RCM2100 module to protect against inadvertent
shorts across the pins or damage to the RCM2100 if the pins are not plugged in
correctly. Do not reapply power until you have verified that the RCM2100 module is
plugged in correctly.