User`s manual

60 RabbitCore RCM2000
A pair of small holes capable of holding 30 AWG wire appears to the side of each hole
pair at locations J2 and J4 for convenience of point-to-point wiring when headers are
installed. The signals are those of the adjacent pairs of holes at J2 and J4. These small
holes are also provided for the components that may be installed below location J4.
There is an additional 2" × 3" of through-hole prototyping space available on the Prototyp-
ing Board. VCC and GND traces run along the edge of the Prototyping Board for easy
access. A GND pad is also provided at the lower right for alligator clips or probes.
Figure B-6. VCC and GND Traces Along Edge of Prototyping Board
GND
VCC
GND pad
GND trace
VCC trace