User`s manual

User’s Manual 43
It is recommended that you allow for an “exclusion zone” of 0.04" (1 mm) around the
RCM2000 in all directions when the RCM2000 is incorporated into an assembly that
includes other printed circuit boards. An “exclusion zone” of 0.08" (2 mm) is recom-
mended below the RCM2000 when the RCM2000 is plugged into another assembly using
the shortest connectors for header J1. Figure A-2 shows this “exclusion zone.”
Figure A-2. RCM2000 “Exclusion Zone”
0.08
(2)
0.08
(2)
0.28
(7.2)
1.980
(50.3)
0.28
(7.2)
Exclusion
Zone
2.380
(60.4)
2.300
(58.4)
1.900
(48.3)