User`s manual

User’s Manual 31
4.4.2 Standalone Operation of the RCM2000
The RCM2000 must be programmed via the RCM2000 Prototyping Board or via a similar
arrangement on a customer-supplied board. Once the RCM2000 has been programmed
successfully, remove the programming cable from the programming connector and reset
the RCM2000. The RCM2000 may be reset by cycling the power off/on or by pressing the
RESET button on the Prototyping Board. The RCM2000 module may now be removed
from the Prototyping Board for end-use installation.
CAUTION: Power to the Prototyping Board or other boards should be disconnected
when removing or installing your RCM2000 module to protect against inadvertent
shorts across the pins or damage to the RCM2000 if the pins are not plugged in
correctly. Do not reapply power until you have verified that the RCM2000 module is
plugged in correctly.