User`s manual

OP710086


 Installation
Mounting
A bezel and a gasket are included with the OP7100. When properly mount-
ed in a panel, the bezel of the OP7100 is designed to meet NEMA 4 speci-
fications for water resistance.
Since the OP7100 employs an LCD display, the viewing angle must be
considered when mounting the display. Install the OP7100 at a height and
angle that makes it easy for the operator to see the screen.
Note that the contrast controls, both manual and software, act
as view-angle controls, and should be adjusted to provide
theoptimum display quality at the angle from which the display
will normally be viewed.
Bezel-Mount Installation
This section describes and illustrates how to bezel-mount the OP7100.
Follow these steps for bezel-mount installation.
1. Cut mounting holes in the mounting panel in accordance with the
recommended dimensions in Figure 6-2, then use the bezel faceplate to
mount the OP7100 onto the panel.
Figure 6-2. Recommended Cutout Dimensions
2. Remove all eight 4-40 locking hex nuts from their studs on the bezel,
and carefully “drop in” the OP7100 with the bezel and gasket attached.
4.600
(117)
7.000
(178)
3.500
(89)
5.380
(137)
0
.180
(4.5)
1.620
(40)
0.125 D, 8x
(3)
1.100
(28)
CUTOUT
0.150
(3.8)
