User`s manual

User’s Manual 147
APPENDIX C.
DEMONSTRATION BOARD CONNECTIONS
Appendix C shows how to connect the Demonstration Board to
the OP7200.
C.1 Connecting Demonstration Board
Before running sample programs based on the Demonstration Board, you will have to con-
nect the Demonstration Board
from the OP7200 Tool Kit to the OP7200 board. Proceed as
follows.
1. Use the wires included in the OP7200 Tool Kit to connect header J1 on the Demonstra-
tion Board to the OP7200. The connections are shown in Figure C-1 for sample program
DIGIN.C, in Figure C-2 for sample program DIGOUT.C, and in Figure C-3 for the
OP7200\TCPIP TCP/IP sample programs.
2. Make sure that your OP7200 is connected to your PC and that the power supply is con-
nected to the OP7200 and plugged in as described in Chapter 2, “Getting Started.”