User`s manual

132 eDisplay (OP7200)
A.3 Jumper Configurations
Figure A-4 shows the header and jumper locations used to configure the various OP7200 options.
Figure A-4. Location of OP7200 Configurable Positions
(RabbitCore module is not shown)
Table A-2 lists the configuration options. 0 Ω surface mount resistors are used for all the
positions except JP10 and J8, which use standard pluggable jumpers.
Table A-2. OP7200 Jumper Configurations
Header Description Pins Connected
Factory
Default
JP1 IN16–IN18
1–2 Pulled up to Vcc
×
2–3 Pulled down
JP2 IN00–IN07
1–2 Pulled up to Vcc
×
2–3 Pulled down
JP1
JP4
JP5
JP6
JP7
JP2
JP3
JP9
J8
JP10
JP8
R62 R64 R65
JP16 JP15 JP14 JP13
JP12
JP11
Battery
R71