User`s manual

124 eDisplay (OP7200)
2. Remove the OP7200 back cover. Set the screws and back cover aside since the back
cover will be re-attached after the OP7200 is inserted through the cutout.
3. Carefully insert the OP7200.
4. Fasten the unit to the panel with the back cover and the four 4-40 screws that attach the
back cover to the OP7200. If your panel is more than 0.1" (2.5 mm) thick, you will
need to supply longer 4-40 screws.
Figure 24. OP7200 Mounted in Panel (rear view)
Carefully tighten the screws until the gasket is compressed by the bezel faceplate.
Do not tighten each screw fully before moving on to the next screw. Apply only one or
two turns to each screw in sequence until all are tightened manually as far as they can
be so that the gasket is compressed by the bezel faceplate.
OP7200 Bezel/Gasket
D23
D20
+PWR PWR +K OUT0 OUT1 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 GND
IN12 IN13 IN14 IN15 /RST TXC RXC TXD RXD 485 +485 GND
J10
J15
IN16 IN17 IN18 AIN0 AIN1 AIN2 AIN3 AIN4 AIN5 AIN6 AIN7 AGND
IN0 IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8 IN9 IN10 IN11
DS1
DS2
J2
J6
J3
J1
R71
R72
R59
R60
R66
C40
C49
C13
D24
2
4
MSTR
SLAVE
D1
D3
D2
D5
D4
Q2
R24
Q4
R23
Q3
R22
Q8
R38
Q7
R37
Q6
R39
Q11
R55
Q10
R56
D6
D8
D9
R64
R62
R65
C86
C29
C30
C16
C17
C18
C6
C8
C7
R91
R14
TVS1
C82
J8
R152
R151
C85
C84
R149
J16
Panel
CAUTION: Disconnect power
before making or removing
terminal connections.
J2
J6
J3
J10
PROG
1
1
1
1
E-Net
R-Net
1
USR PWR
LNK ACT

+