User`s manual

User’s Manual 123
6.3 Mounting Instructions
The OP7200 comes with a gasket attached to the bezel. When properly mounted in a
panel, the OP7200 bezel/gasket are designed to meet NEMA 4 specifications for water
resistance.
Since the OP7200 employs an LCD display, the viewing angle must be considered when
mounting the display. The viewing angle is affected by the software-controlled contrast.
Install the OP7200 at a height and angle that makes it easy for the operator to see the
screen.
6.3.1 Bezel-Mount Installation
This section describes and illustrates how to bezel-mount the OP7200. Follow these steps
for bezel-mount installation.
1. Cut a mounting hole in the mounting panel in accordance with the recommended dimen-
sions in Figure 23, then use the bezel faceplate to mount the OP7200 onto the panel.
Figure 23. Recommended Cutout Dimensions
4.96
(126)
3.82
(97)
CUTOUT
0.51
(13)
Bezel
4.41
(112)
5.67
(144)