User`s manual

122 eDisplay (OP7200)
6.2 Installation Guidelines
When possible, following these guidelines when mounting an OP7200.
1. Leave sufficient ventilation space, at least 1" (2 cm) around the unit on all sides.
2. Do not install the OP7200 directly above machinery that radiates a lot of heat (for
example, heaters, transformers, and high-power resistors).
3. Leave at least 8" (20 cm) distance from electric power lines and even more from high-
voltage devices.
4. When installing the OP7200 near devices with strong electrical or magnetic fields (such
as solenoids), allow a least 3" (8 cm), more if necessary.
The OP7200 has strong environmental resistance and high reliability, but you can maxi-
mize system reliability by avoiding or eliminating the following conditions at the installa-
tion site.
• Abrupt temperature changes and condensation
• Ambient temperatures exceeding a range of 0°C to 50°C
• Relative humidity exceeding a range of 20% to 70%
• Strong magnetism or high voltage
• Corrosive gasses
• Direct vibration or shock
• Excessive iron dust or salt
• Spray from harsh chemicals