User`s manual

6 www.rabbit.com Introduction
1.2.3 EM1500 Factory Defaults
Every EM1500 is shipped with default values for some of the configuration parameters already set. Some
parameters have been left blank where it makes no sense to have a default, such as the IP address and net-
mask for the unit. The following table gives all of the factory defaults. To reset your unit to these defaults,
press down the reset switch for 10 seconds. Parameters that have been left blank or are zero, are not
included in this table.
Table 1-3. EM1500 Default Configuration Parameters
Configuration
Category
Configuration Parameter Default Setting
General
Unit Name EM1500-fac-dflt
TCP Keepalives 7200
Aux I/O
Direction/State PF0-4 In/Low
State OUT0 and OUT1 Hi-Z
Relay Open
Network (Ethernet)
Enable Connections ON
Use DHCP ON
Ping configure ON
Enable config ON
Enable discovery ON
Serial (Basic)
Speed 115200 (SER4) 19200 (all others)
Geometry 8N1 (all serial ports)
Flow control (Tx and Rx) None (all serial ports)
Relay action None (all serial ports)
Relay timer (ms) 10000 (all serial ports)
Modem Emulation
AT command set OFF (all serial ports)
DSR/DTR control Active (all serial ports, except RS485)
CTS/RTS control Active (all serial ports, except RS485)
DCD control Active (SER2 only)
RI control OFF (SER2 only)
Use PF0-3 OFF (SER3 only)
RS232 levels OFF (SER3 only)
Polling Enable poll OFF (all serial ports)