User`s manual

RabbitFLEX User’s Manual www.rabbit.com 15
Problems During and/or at the End of Compilation
• A few computers have trouble handling the default 115,200 baud rate. Change the stop bits from 1 to 2
in the Communications tab of Project Options. If that does not work, slow the baud rate to 57,600 and
try the compilation again.
2.7 Contact Information
If there are any questions at this point:
• If you purchased your RabbitFLEX BL300F through a distributor or through a Rabbit partner, contact
the distributor or partner first for technical support.
• Check the Rabbit Technical Bulletin Board at: www.rabbit.com/support/bb/.
• Use the Technical Support e-mail form at: www.rabbit.com/support/.