Cut Sheet

VX/ VXBR CFL INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [e-mail]
TROUBLESHOOTING
1. Is the proper lamp installed?
2. Make sure the lamp is not defective. Try a lamp known to
be in operating condition.
3. Check that the line voltage at xture is correct. Refer to
wiring directions.
4. Is there voltage at the lamp socket? If there is no voltage,
check all connections.
5. Is the xture grounded properly?
ACCESSORIES
Die Cast Guard: GD100DG
GD200DG
Wire Clamp Flat Bottom: GD100BAR
GD200BAR
Wire Clamp Round Bottom: GD100CL
GD200CL
REPLACEMEN T L A M PS AN D BALLA ST S
RAB Lamp RAB Ballast
Wattage Catalog# Catalog#
Compact Fluorescent Lamp
13 LCFL13Q-4P BCFL13-4E
26 LCFL26 BCFL42
32 LCFL32 BCFL42
42 LCFL42 BCFL42
LAMP INSTALLATION
CAUTION: Prior to installing, check that the lamp is
the correct wattage. Observe lamp manufacturer’s
recommendations on lamp operation, ballast type and
burning positions.
1. Disconnect power. Make sure xture and lamp are cool
enough to touch.
2. Open xture by unscrewing guard and globe from
xture.
3. Fully insert the lamp into the socket.
4. Replace globe and guard.
5. Tighten screws.
WIRING
Use supply wire rated for 90°C. The units are wired for
120V. Units built for a specic voltage are factory-wired
for the requested voltage. Make sure the supply voltage
is compatible with the unit. Multi tap units may be used
with a choice of 120V, 208V, 240V and 277V, provided
that proper ballast leads are connected in the eld.
1. Connect the black xture lead to the (+) LINE supply lead.
2. Connect the white xture lead to the (-) COMMON supply
lead.
3. Connect the Ground wire from xture to supply ground.
4. All unused leads must be capped and insulated.
CLEANING & MAINTENANCE
CAUTION: Be sure xture temperature is cool enough to
touch. Do not clean or maintain while xture is energized.
1. Clean glass lens with non-abrasive glass cleaning solution.
2. As lamps age, light output diminishes. Mass re-lamping
at regular intervals ensures full light output at the highest
eciency.
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2012 RAB LIGHTING Inc.
No
rthvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
email
Answered promptly [e-mail]
VX/ VXBR CFL-IN 0113
LIGHT
FIXTURE
(+)LINE BLACK
(-)COMMON WHITE
GROUND GROUND
Note: These instructions do not cover all details or variations in
equipment nor do they provide for every possible situation during
installation, operation or maintenance.