Installation Manual

Aiming And Walk Testing
Walk Test
The purpose of the Walk Test is
to check and adjust the coverage
pattern. Stealth has a 5 minute Test
Period which allows the sensor to
be aimed and walk tested day or
night. If you require 5 more minutes
of Test Time, turn the power off for
at least 10 seconds and back on
again. During the Test Period, the
sensor will keep lights on for 5
seconds each time it detects move-
ment in its Detection Zone. The
sensor will change to Automatic
Mode after 5 minutes of testing.
To enter Test Mode:
Turn power off for at least
10 seconds and back on.
1. Aim the sensor across the traffic
pattern you want to detect. Start by
aiming the sensor downward and
then raise it slowly until the desired
range is obtained.
2. Start outside the pattern and
walk across the pattern until the
lights go on. As distance from the
sensor increases, it will take more
movement to be detected.
3. Adjust the sensor aiming as
necessary to improve coverage.
4. To adjust the sensitivity turn knob
gently. Less sensitivity (counter-
clockwise) may be desired if you
wish to detect a limited area or if
the sensor is being activated by
wind, foliage or animals. More
sensitivity (clockwise) will help
cover a larger area.
5. Repeat steps #2 thru #4 until you
are satisfied with the coverage.
6. The “Time” control is factory set
at approximately 5–8 minutes. This
period starts after the movement in
the detection pattern ceases. If less
time is desired, turn the time control
counterclockwise. For more time,
turn the knob clockwise.
7. Stealth is factory set for night
only operation. To obtain 24 hour
operation, turn the photocell control
full counter clockwise. Intermediate
settings will adjust operation during
dusk and dawn.
8. Your sensor is ready for operation.
See the Technical Tips pages 7-11
if additional help is needed.
Control Panel:
SENS PHOTO TIME
Minimum
30%
Maximum
100%
24 Hour
Operation
Night
Operation
5 Sec
12 Min
Animal Alley
Start Finish
6