Instruction Manual
INSTRUCTIONS
WALL MOUNT
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Min 90 °C SUPPLY CONDUCTORS.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
WARNING: Do not use an electric generator to test LED xtures.
CAUTION: For proper weatherproong function, all gaskets must be seated properly and all screws inserted and tightened.
This is important with an uneven wall surface. Silicone all plugs and unused conduit entries.
For wet location compliance, xture must be properly sealed. For moisture seal, apply silicone caulking between the
mounting surface and back housing, as well as around the sides of the housing. This is important with uneven wall surface.
SLIM17 FA 40-60W
Housing Screws (2
Fig. 1.
Housing Back Plate (Fig. 2)
Plug
Housing Back Plate
Foam Gasket (provided)
Housing Back Plate
Housing Back PlateFig. 3
Housing Back Plate
Fig. 4Housing
(Fig. 8Housing
Housing Back Plate
(supplied by others) Screws (supplied by others)
Fig. 5
Housing Housing Back Plate
2) Screws (provided) Fig. 6.
Conduit ide Conduit Cap
Fig. 1
Housing
(Fig. 8Housing
Housing Back Plate
Foam Gasket
SLIM17 FA 100-120-150W
Plug
Installation Holes
Junction Box
Housing Screws (2)
Housing
Housing Screws (2)
Side Conduit