Instruction Manual
INSTRUCTIONS
BRISK® 17 FA WALL PACK FIELD ADJUSTABLE INSTALLATION
WALL MOUNT
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
WARNING: Do not use an electric generator to test LED xtures.
WARNING: Min 90 °C SUPPLY CONDUCTORS.
CAUTION: For proper weatherproong function, all gaskets must be seated properly and all screws inserted and tightened.
This is important with an uneven wall surface. Silicone all plugs and unused conduit entries.
For wet location compliance, xture must be properly sealed. For moisture seal, apply silicone caulking between the
mounting surface and back housing, as well as around the sides of the housing. This is important with uneven wall surface.
Housing Screws (4) Fig. 1.
Housing Back Plate Plug
Fig. 2
Foam Gasket (provided)Housing
Back Plate
Housing Back PlateFig. 3
Housing Back Plate(supplied by
others) (2) Screws (supplied by others)
Fig. 4
Housing Back Plate
Fig. 5Housing
Fig. 9
Housing Housing Back Plate
(4) Screws (provided) Fig. 1.
Side ConduitSide Conduit Cap
Fig. 1
Fig. 5
Fig. 9
Housing
Foam Gasket
Screws (2)
Housing Back
Plate
BRISK17 FA
Housing
Side Conduit
Cap
Screws (4)
Plug
Housing Back
Plate