Instructions
INSTRUCTIONS
TSLED
™
INSTALLATION
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Indoor use only
Load:
Operating Frequency:
Operating Temperature: 0°C to +55°C (32°F to +131°F)
Factory Settings:
• Time Delay: 15 minutes
Lights remain at full output for this amount of time after
motion is no longer detected in sensor’s coverage area
• Sensitivity: 80%
This ultrasonic sensor uses high frequency to detect room
occupancy and motion.
• If settings other than Factory Settings are desired, see
CUSTOMIZATION (pg 2) for more information
• If room is vacant for selected Time Delay, lights turn o
or dim
• LED ashes upon sensing motion and lights turn back on
Override Mode
•
•
• LED (no blinking)
• To cancel Override Mode, press Test Mode Button once
Burn-In Mode
• est Mode Button fo
•
• LED fBurn-In
Fail-On Mode
• Using N/C (Normally Closed)* wiring, xture will turn on if
sensor fails
Test Mode: use walk test to adjust coverage if needed
• Remove sensor cover from xture
• Press Test Mode Button once to enter test mode
• Test period lasts 5 minutes with 5 second Time Delay
• Sensor returns to previously set Time Delay following
the test period
• Walk in and out of coverage area to check and adjust
sensor:
• Lights remain on and LED ashes until detection
area is vacated (continuous ashing indicates motion
detection)
• After 5 seconds the LED should stop ashing and the
light should turn o or dim
• Adjust sensitivity to desired coverage and repeat as
needed
19400
1 2
ON
1
ON
O
LED
Sensitivity
Setting
IMPORTANT