Installation manual

1. Attach the Universal Mounting
bar with the bar screws (provid-
ed) to the junction box. If you are
attaching your STL200 kit to a
surface mount weatherproof box,
you must use both gaskets, with
the metal mounting plate
sandwiched between.
2. Easy Wiring Tip:
Use the “S” shaped Hands Free
Hanging Hook to hold the EZ
Plate during wiring.
3. Bring power leads and sensor
kit leads through holes in all
gaskets into junction box.
4. Strip
1
/2" of insulation from
all leads.
5. Attach ground wire(s) to junction
box grounding screw. Connect
as shown in wiring diagram. See
page #6.
6. Twist on wire nuts. Secure with
electrical tape.
7. Align gaskets, EZ Plate and
metal mounting plate to insure
proper seal. Tighten EZ Plate
center screw (make sure O-Ring
gasket is on the screw) to attach
EZ Plate to the box.
8. Insert plastic Finishing Cap in
the center of the EZ Plate for a
weatherproof seal.
9. Use silicone sealant around all
openings to insure a
weatherproof seal.
10. Screw in light bulbs. Turn on
power. Conduct walk test to adjust
Red pigtail is only used to switch remote or
additional fixtures.
Kit Wiring
4
Bar
Screws
Metal Mounting
Plate
CU4 EZ
Plate
Universal
Mounting Bar
Gasket
O-RingGasket
Insert
close-up
plug in
unused
hole
Finishing
Cap
EZ Plate