User Manual

6
❏ Center the sensor on the space. The sensor location on the plan should
indicate if the sensor is centered on the room or above a specific area of the
room.
❏ Locate the Sensor on the nearest ACT Frame. This may be slightly off-center of
the room.
❏ Use the included Frame clip to attach the Counter to the Frame as shown in
the next slide.
PART TWO - OPTION 1 - Using a Clip
Your Sensor should ship with an twist/clamp-on attachment to match your ACT
System.
Use the location determined using the guidelines on the previous sheet
❏ Attach using Frame Clip (image right):
❏ Squeeze the Clamp onto the T-Bar
❏ Twist the Counter onto the Stem
❏ Orient the Counter with the white lens at the top of the floor plan. Do Not
Overtighten