Product Info

R.V.R. Elettronica S.r.l. - Via del fonditore 2/2 c 40138 Bologna (Italy)
Tel. 0039 0516010506 r.a.- Telefax 0039 0516011104 E-mail: info@rvr.it
Reg. Impr. e Cod. Fisc/Part. IVA 02124450376 R.E.A. BO 252844 Pos. Mec. Bo 9077
BroadcastEquipment
4) When the display is off, touching any key will turn on backlighting.
When the display is on, pressing the ESC button from the default menu (menu 1) calls up the
selection screen (menu 4), which gives access to all other menus:
Menu 4
Select “Pwr Menu” , then press ENTER to confirm.
5) Ensure that the equipment is not in a locked-out state. Press ESC to call up the selection screen
(menu 4).
Highlight Fnc and press ENTER to confirm and access the selected menu (menu 5).
If PWR is set to OFF, i.e. power output is disabled, move cursor to PWR. Press ENTER and label will
switch to ON, i.e. power output is enabled:
Menu 5
Press ESC twice to go back to the default menu (menu 1).
6) Fine tune power setting from menu 3 (see description of item 3) until achieving the desired value.
WARNING: Equipment is capable of delivering more than rated output; however, never exceed the
specified power rating.
NOTE: If power is set to 0 W in the Power Setup Menu, the INTERLOCK OUT contact is activated and
any external appliances connected to it are immediately inhibited.
Next, you can review all operating parameters of the equipment through the management
firmware.
Normally, the equipment can run unattended. Any alarm condition is handled automatically by the
safety system or is signalled by the LED indicators on the panel or by display messages.
NOTE: Standard factory settings are output power set to upper limit (unless otherwise specified by
customer) and OFF.