User Manual

NOTCHCELL 20W OPERATING MANUAL
R-tron America, Inc. Page: 56 / 57
Appendix B. Modem
B.1 System Window
B.1.1 General Control
 Communication Port : Connects MCU to the modem port.
 Modem Own Number : Refers to the modem number, with which you can call using
a modem.
 Firmware Version : Refers to the version of currently used software.
B.1.2 WNMC Configuration
 Cascade Code : Refers to the ID designated by operator where the repeater is
installed. The ID is composed of ten-digit characters and figures.

► Note : How to display cascade ID (ex :XX##YY$$$$)
① XX : First two-digit characters showing the installation site of the repeater.
If the repeater is installed in Boston, XX is seen as ‘BS’.
② ## : Shows whether the repeater is installed inside/outside of a building: In
Building System (Indoor type)/Macro System (Outdoor type).
③ YY : Shows device types (Repeater/cell site).
If the system is found as repeater, YY is ‘XR’; if it is a cell site, YY is ‘XC’.
④ $$$$ : Refers to integers (1 ~ 9,999) indicating the number of repeaters installed
in XX.
If 24 repeaters are installed in Boston (BS), $$$$ is ‘24’.
B.1.3 Control
The Control window is to set the periodic interval of the Heartbeat. This function lets
you set the time interval of the Heartbeat to 3 ~ 59 minutes.