User Manual

NOTCHCELL 20W OPERATING MANUAL
R-tron America, Inc. Page: 38 / 57
5.5.3 Communication Port and Speed Configuration
You should set the communication speed and port between your computer and
Notchcell for mutual communication.
User can set communication speed and port which control button is located upper
left-side in the main window screen. After that, communication is started.
(Communication Speed : 38,400 bit / second)
Figure 5.10 Communication Port and Speed Configuration
► Note : How to check computer communication port
1. Go to “Windows Control Panel”.
2. Go to “Function and Maintenance Management”
3. Go to “System”
4. Go to “Hardware”
5. Go to “System Management”
6. Go to “Port”
7. Check “Communication Port”
5.5.4 GUI Communication
When it is properly communicated between computer and repeater MCU board, Tx /
Rx yellow LED will be lit which is located the left-upper end in the GUI screen.
Figure 5.11 Communication Check LED