User Manual

NOTCHCELL 20W OPERATING MANUAL

R-tron America, Inc. Page: 26 / 57

Assemble the Conduit End Cap (repeater accessory) at both ends of 36mm Flexible

Conduit.

Insert the assembled 1/2” feeder cable (shield cable) into the 36mm Flexible Conduit.

Figure 3.20 Feeder Cable at Repeater Side

After installing and tying the cable, connect the connector to the bottom of the antenna

and then apply the Conduit End Cap.

Figure 3.21 Connector on the Antenna Side

Compress the Shield cable on the repeater with the heat shrink tube.

Connect the feeder cable connector to the arrestor onto the bottom of the repeater, and

then apply the Conduit End Cap.

Figure 3.22 Installing the connector on the repeater side

Connector

Conduit End Ca