User Manual
RSP-APA-002
User’s Manual
R-tron., Inc. 31/34 page
1. Modem system window
▶ General control
- Communication Port : Connects MCU to the modem port. You can refer to the same settings
as those in the main GUI.
- Modem own number : Refers to the modem number, with which you can call using a modem.
- Firmware version : Refers to the version of currently used software.
▶ WNMC configuration
- Cascade code : Refers to the ID designated by operator where the repeater is installed. The
ID is composed of ten-digit characters and figures. It may appear in the following form:
XX##YY$$$$
ㅤ① XX : First two-digit characters showing the installation site of the repeater.
If the repeater is installed in Boston, XX is seen as ‘BS’.
② ## : Shows whether the repeater is installed inside/outside of a building: In Building
System (Indoor type)/Macro System (Outdoor type).
ㅤ ③ YY : Shows device types (Repeater/cell site).
If the system is found as repeater, YY is ‘XR’; if it is a cell site, YY is ‘XC’.
ㅤ ④ $$$$ : Refers to integers (1 ~ 9,999) indicating the number of repeaters installed in XX.
If 24 repeaters are installed in Boston (BS), $$$$ is ‘24’.
▶ Control
The Control window is to set the periodic interval of the Heartbeat. This function lets you set
the time interval of the Heartbeat to 3 ~ 59 minutes.
▶ Modem Configuration
- Network Connection :
① Modem mode : This button lets you see the modem status. When you press the button,
the Modem Status window, the Modem Configuration window, the Modem Statistics
window, and the Modem Status window are activated. With the [NMST] button in the
Modem Status window, you can see modem status.
② PPP mode : Stands for Point to Point Protocol, which helps set connection between the
MCU and WNMC. PPP connection is automatically set. Facing connection failure, MCU
retries until the connection is successful. When PPP is fully set, the Modem Status window,
the Modem Configuration window, and the AT Command window are automatically de-
activated.
③ WNMC : This button lets you clear PPP connection. You can see whether PPP is
connected/disconnected depending on the icon color of the WNMC button. You can see the
connection status in the window next to the WNMC button. You can have access to the PPP