User Manual

RSP-APA-002
User’s Manual
R-tron., Inc. 23/34 page
5.3 How to operate GUI and Functions
Repeater can be controlled in Set-up mode. In Set-up pop-up window, you can input the value and
control DL/UL Path, ALC, Shut down and attenuation. When you are going to change the setting value,
you should click “Set” button which is in up-right side in the GUI screen.
When you are going to check repeater status, click “Status mode” button which is in the up-right side
in the screen. And then check the value which is displayed in “Status mode” and you can change
output value, using attenuation value. After setting output value, you can set ALC/ASD level value,
using ALC button.
Figure 5.7 Setup mode