User Manual

RSP-APA-002
User’s Manual
R-tron., Inc. 15/34 page
4.4.3 Installing Antenna
4.4.3.1 Precautions
- Antenna is an elaborated device. Therefore, be careful, not damaged and not transform.
- When you install the antenna, do not hurry and do not overpower.
- Antenna sustain plate should be zinc.
- Select proper antenna installation candidate place which keeps away from topological
obstacles or higher buildings for good frequency receipt and transmittance.
- Install antenna in a place which is not blocked or sufficiently isolated from the high-
voltage cable to avoid spurious signal.
- An angle between each antenna and sustain plate should be under 60 degrees.
4.4.3.2 Installing Antenna
- Antenna should be fixed firmly and do not shake by external impact or wind.
- Using FRP(Φ48.6x2500), antenna fix pipe can be fastened.
- Between donor and distributor antenna should be isolated 59 inches at least.
- To avoid antenna shivering, donor and distributor pipes should be fixed by an angle.